Gas&liquid mixture pump is a series of self-priming Gas&liquid mixture pump installed horizontally. It adopts special motor direct-connection structure and standard motor-shaft coupling connection. The structure and performance of the pump are all imported from foreign technology. The flow parts of the pump are all made of stainless steel.

If the Gas&liquid mixture pump is rotated, the water flow will be reversed. The reverse of the water flow may cause the pump to have no water to deliver, or the water will come out from the air inlet. Even if the water flow is positive, there will be a sharp sound when the gas and liquid are mixed, and the pump is not closed before closing. The air line will also leak water from the air intake. Therefore, the reverse installation will have a destructive effect on the future air source device, such as the ozone generator, and the pump itself will not be damaged if it is reversed for a short time. After the pump is connected to the power supply, touch the power switch to observe whether the rotation of the fan in the motor cover at the rear of the motor is consistent with the rotation arrow on the motor cover, and then run the equipment after confirming that it is correct.
The suction port of the Gas&liquid mixture pump can use the negative pressure to suck in the gas, so there is no need to use an air compressor and an atmospheric ejector. The high-speed rotating pump impeller mixes the liquid with the gas, so there is no need for agitators and mixers.