The biggest feature of the Submersible borehole pump for 10 inch is that the motor and the pump are made into one. It is a pump that is immersed in the groundwater well for pumping and conveying water. It is widely used in farmland irrigation and drainage, industrial and mining enterprises, urban water supply and drainage and sewage treatment. Wait. Today, the manufacturer of Submersible borehole pump for 10 inch will show you how to install the unit.

1. First, install a section of the pump pipe at the water outlet of the pump, clamp it with a splint, lift it and drop it into the well, so that the splint sits on the well platform.
2. Use a pair of splints to clamp another section of the water pipe. Then hoist and lower it to connect with the flange of the water pipe and the rubber pad. When screwing the screw, it must be done diagonally at the same time. Lift the hoisting chain to remove the first pair of splints, so that the pump tube lowers the splint and falls on the well platform again. The manufacturer of Submersible borehole pump for 10 inch tells you to repeatedly install and go down in sequence until all the installations are completed, put on the manhole cover, and put the last pair of splints on the manhole cover without dismantling it.
3. Install elbows, gate valves, water outlets, etc., and add corresponding rubber gaskets to seal.
4. The cable should be fixed in the groove on the flange of the water pipe, and each section should be fixed with a rope. Be careful not to damage the cable during the process of going down.
5. If there is a stuck phenomenon in the process of lowering the pump, try to overcome the stuck point, and do not force the pump to avoid getting stuck.
6. The manufacturer of Submersible borehole pump for 10 inch tells you that it is strictly forbidden for personnel to go down during installation.
7. The protection switch and starting equipment should be installed behind the user's switchboard, which has a voltmeter, ammeter, and indicator lights, and should be placed in a proper position in the well room.
8. The manufacturer of Submersible borehole pump for 10 inch tells you to adopt the forcible protection measures of "bundling with iron wire from the motor base to the pump pipe" to prevent accidents.