The manufacturer of Submersible borehole pump for 8 inch tells you that many people are concerned about the maintenance of submersible pumps. They either don’t have time or don’t care. In fact, as a mechanical equipment, your approach is wrong, which will reduce the machine’s The service life, let's take a look at its maintenance method.

The manufacturer of Submersible borehole pump for 8 inch tells you that the submersible pump plays a relatively large role when it is used. But what you must know is that it must be well maintained. The maintenance of submersible pumps is a regular task, and the quality of maintenance work directly affects the energy-saving operation rate and service life. The main content of the submersible pump maintenance is to ensure the reliable operation of the submersible sewage pump and prolong the service life, so it is said that it is used for a period of time. Then it is necessary to carry out comprehensive maintenance on the submersible pump and its control system on a regular basis. The work you have to do is to do a comprehensive preventive maintenance at least once a year, and this includes the vibration sound and whether the voltage and current are abnormal when it is turned on. . Whether the starting device works normally, whether the over-temperature water leakage alarms, whether the multiple protections established by the meter control operate frequently, and whether the main cable and the control cable are aged and cracked. So these are also issues that cannot be ignored. In addition, the submersible borehole pump for 8 inch manufacturer will tell you whether the main contactor of the submersible pump has sticky oxidation or burrs, whether the thermal relay is set correctly, whether the winding insulation layer has signs of aging, and whether the insulation resistance to ground is Too low is also to be checked. As long as these places do well, there will be no problem.
Therefore, the maintenance of the submersible pump is also very important. In addition, it is also necessary to check whether the resistance of the three-phase windings is balanced, whether there are sweeps or scratches on the stator and rotor, and whether the liquid level gauge of the control system is accurate. The manufacturer of Submersible borehole pump for 8 inch will tell you whether its upper and lower limit output is normal and reliable, whether the floating ball action is reliable, whether the temperature detection element is aging and malfunctioning, whether the oil is emulsified, whether the mechanical seal is in good condition, and whether the bearing is worn. If there is a problem, it cannot be operated. Of course, it also needs to be repaired in time. The manufacturer of Submersible borehole pump for 8 inch tells you that you need to check whether the impeller of the submersible pump is worn or cavitated, whether the shaft is rusted, deformed or worn, and whether the fastening screws inside and outside the motor are loose. If the component is aging, you only need to connect its signal to the alarm signal. It is also recommended that you do not let it directly participate in the control, so that the frequent start of the submersible pump can be reduced. Of course, its connecting fasteners are not loose, and the joint surface has no oil leakage, no water leakage, and no ink leakage. If you still don't understand anything, you can ask here. Welcome to buy products that suit you.
By telling everyone about the maintenance tips of submersible pumps, we will know these when we use them in the future. The manufacturer of Submersible borehole pump for 8 inch tells you to read it carefully if you don't know it yet. Well, today's knowledge points are here first, I hope it can help everyone.